Thursday, May 29, 2014

Disassembly: How To Repair Sewing Machines

 

How To Disassemble A Sewing Machine.

 

One of the most time consuming parts of any sewing machine repair is the disassembly.  On many machines this is as simple as removing a few screws, but on other machines it can be a bit more complicated. 

Many of the newer machines use a snap fit system that requires the technician to find the snap points, and release them by pressing one side of the cover in while the other remains rigid.  Unless all the appropriate screws have been removed and the proper order followed, removing the covers can be quite frustrating. 

Keeping your parts including screws well organized is essential.  Otherwise, as you reassemble, you will find extra screws and the covers may not align.  For this reason, be sure to keep covers with their correct screws.  If necessary, tape the screws in place temporarily.  The more complicate the machine is, the more important organization of parts becomes.


 
Disassembly should proceed from right to left.  Remove the tray, the lower arm cover, and the needle bar cover.  Remove the needle, needle plate, bobbin carrier or case, and the hook cover and hook.  Begin removing screws across the back from right to left.  Remove any other screws as needed from hand wheel side, and bottom of the machine.

 
Once the covers have been removed, proceed to brush and blow away debris.  Use solvent to dissolve old lubrications.  Use pure clean sewing machine oil, and place one drop everywhere metal touches metal.



 
Notice this Brother XL sewing machine has an oscillating hook system.  You can see the bracket for the hook inside and the race outside.
 





 
To learn  more about sewing machine, serger repair, embroidery machine, and industrial machine repair, check out http://www.FixSewingMachines.com.  The Fix Sewing Machines Institute offers comprehensive sewing machine repair training in both live institutes and by correspondence.
 


8 comments:

Anonymous said...

You are wonderful!

How could you singer 6012c top cover (pattern stitch plastic part) remove ?

How did you singer 6012c 's pattern stitch lever remove ?

Need some - or + screw driver ?


Thank you.

Unknown said...

BSM Company supplier of Industrial Sewing Machine.we are dealing all type Direct Drive Motor Power/Energy Saving Machine, Industrial Sewing Machine Supplier. Juki, Brother,Jack Sewing Machine

Радомир Эра said...

If you had financial problems, then it is time for you to smile. You only need to contact Mr. Benjamin  with the amount you wish to borrow and the payment period that suits you and you will have your loan in less than 48 hours. I just benefited for the sixth time a loan of 700 thousand dollars for a period of 180 months with the possibility of paying before the expiration date. Make contact with him and you will see that he is a very honest man with a good heart.His email is lfdsloans@lemeridianfds.com and his WhatApp phone number is + 1-989-394-3740 

MaintenanceRepairServicellc said...

This is a blog to read out for sure. I found you have a really awesome writing style.Its simple and easy to understand.Your blog design is so clean too! Thank you for all the hard work!Machine tools

MaintenanceRepairServicellc said...

I really loved reading your blog. It is very well authored and easy to undertand. Unlike so many other blogs I have read which are really not that good. I also found your posts very interesting. In fact, after reading, I shared it with my friends and everyone liked it!
Iron workers

Anonymous said...

My SINGER heavy duty sewing machine have a problem with the stitches knob.It can only stitch straight line stitch even if you turn the knob to other stitches.How can i fix it myself?Care to show how to fix it if you knew sir.TQ

Anonymous said...

very good quality posts thanks for shearing. usha electric sewing machine

aaavacuumandsewingmedia said...
This comment has been removed by the author.

Post a Comment